Auto Soap Dispenser product failure maintenance common sense

Release Time:

Oct 01,2021

Before installing the Auto Soap Dispenser product in the sink, it is necessary to explain that not all sinks can be equipped with the Auto Soap Dispenser product.

Auto Soap Dispenser product failure maintenance common sense

Before installing the Auto Soap Dispenser product in the sink, it is necessary to explain that not all sinks can be equipped with the Auto Soap Dispenser product, as long as the sink with the Auto Soap Dispenser product hole can be installed. Before installation, choose the matching type between the Auto Soap Dispenser product requirements of the sink and the Auto Soap Dispenser product hole. If the type is not correct, it cannot be installed. When installing, you only need to align the Auto Soap Dispenser product of the sink with the Auto Soap Dispenser product hole, according to clockwise or counterclockwise. Rotate and fix the direction. After installation, it can be checked whether the Auto Soap Dispenser product of the sink can be put into operation normally.

good price and quality Auto Soap Dispenser factory
If the Auto Soap Dispenser product is left for a period of time, there may be some agglomeration of soap. If the amount of soap is small, stir it with warm water. This can reduce the soap to liquid. If the above method is not feasible, remove the agglomerated soap. Remove the liquid, add warm water again, and use Auto Soap Dispenser repeatedly until the warm water drains from the Auto Soap Dispenser product, so that the entire Auto Soap Dispenser product can be cleaned.
Note that dust and impurities in the soap will block the outlet. If you notice that the soap in the inner bottle has changed, please replace the soap.
If the soap is too thick, the Auto Soap Dispenser product may not leak out. In order to dilute the soap, add less water and agitate it.
When using the product for the first time, first use the clean water to drain the vacuum inside. When using the soap solution, the inner bottle and pump head may contain some clean water when the product is used for the first time. This is not a product quality problem but a product leaving the factory. Passed on during the previous test.
According to the above introduction, everyone knows how the Auto Soap Dispenser product is used, and when there is a problem, you also know the troubleshooting method of the Auto Soap Dispenser product. Compared with other automatic equipment, the Auto Soap Dispenser product is relatively simple, so the maintenance It won't be too much trouble, everyone just be careful.