Precautions for installation of Auto Soap Dispenser products
Release Time:
Sep 29,2021
Auto Soap Dispenser products need to pay attention to many problems when installing, the following Auto Soap Dispenser manufacturers will take you to understand.
Auto Soap Dispenser products need to pay attention to many problems when installing, the following Auto Soap Dispenser manufacturers will take you to understand.
1. Choose a suitable location, drill a bottom hole in the concrete wall with a percussion drill, and install a rubber plug. Then fix the metal frame to the wall with screws.
2. The Auto Soap Dispenser manufacturer tells you to fix the control box to the metal frame with screws, and then put the soap dispenser box on the metal frame. (Note: Please confirm the vertical distance between the nozzle of the soap dispenser and the bottom of the metal frame, so as not to leak liquid)
3. The Auto Soap Dispenser manufacturer tells you to choose a suitable position on the table, use a percussion drill to make a round hole (25mm in diameter is appropriate), then install the faucet and fasten it with a nut. When installing, pay attention to the distance between the sensor soap dispenser and the faucet to prevent malfunction; the center of the round hole is away from the edge of the sink to ensure that the soap dispenser can drip into the sink.
4. First install the clamp on the tube of the soap dispenser, then connect the tube of the soap dispenser to the pipe on the faucet with a joint, and finally clamp it with the clamp.
5. Connect the gear pump motor wire, sensor head cable, and power cord to the control box as shown in the figure. When connecting the sensor head cable, tighten it with a nut.
6. The Auto Soap Dispenser manufacturer tells you to check whether the power is plugged in. Please fully insert the adapter plug into the power socket.
7. The Auto Soap Dispenser manufacturer tells you to check whether the soap dispenser tube is fully connected and tightened.
8. The Auto Soap Dispenser manufacturer tells you that finally, please check whether the pump motor wire and the induction head cable are completely connected and fastened.
More information
Add :No 3-1 Bldg., No 8, Pingxi 7 Rd., Nanping S&T Park, Zhuhai, Guangdong
IDENTIFY ATTENTION
Follow us