How to install Auto Soap Dispenser product
Release Time:
Sep 16,2021
Auto Soap Dispenser, also called sensor soap dispenser, is a device that automatically delivers soap by sensing the human body. Because of its exquisite design, this device is healthy and environmentally friendly to use, and can effectively avoid secondary cross-infection. How to install Auto Soap Dispenser? Let’s take a look at it below.
Auto Soap Dispenser, also called sensor soap dispenser, is a device that automatically delivers soap by sensing the human body. Because of its exquisite design, this device is healthy and environmentally friendly to use, and can effectively avoid secondary cross-infection. How to install Auto Soap Dispenser? Let’s take a look at it below.
1. Choose a suitable location, drill a bottom hole in the concrete wall with a percussion drill, and install a rubber plug. Then fix the metal frame to the wall with screws.
2. Fix the control box to the metal frame with screws, and then put the soap dispenser box on the metal frame. (Note: Please confirm the vertical distance between the nozzle of the soap dispenser and the bottom of the metal frame, so as not to leak liquid)
3. The Auto Soap Dispenser manufacturer reminds you to choose a suitable position on the table, drill a round hole with a percussion drill (25mm in diameter is appropriate), then install the faucet and fasten it with a nut. When installing, pay attention to the distance between the sensor soap dispenser and the faucet to prevent malfunction; the center of the round hole is away from the edge of the sink to ensure that the soap dispenser can drip into the sink.
4. First install the clamp on the tube of the soap dispenser, then connect the tube of the soap dispenser to the pipe on the faucet with a joint, and finally clamp it with the clamp.
5. Connect the gear pump motor wire, sensor head cable, and power cord to the control box as shown in the figure. When connecting the sensor head cable, tighten it with a nut.
6. The Auto Soap Dispenser manufacturer reminds you to check whether the power is plugged in. Please fully insert the adapter plug into the power socket.
7. Please check whether the tube of the soap dispenser is fully connected and tightened.
8. The manufacturer of Auto Soap Dispenser reminds you to check whether the wheel pump motor wire and the induction head cable are fully connected and fastened.
More information
Add :No 3-1 Bldg., No 8, Pingxi 7 Rd., Nanping S&T Park, Zhuhai, Guangdong
IDENTIFY ATTENTION
Follow us